User's Manual
3.
Configure the device with the following Automatic Update settings:
a.
Automatic Update is done every 24 hours (1440 minutes):
♦
♦
b.
Automatic Update of software file (.cmp):
♦
♦
c.
Automatic Update of Call Progress Tone file:
♦
♦
d.
Automatic Update of ini configuration file:
♦
♦
e.
Enable Cyclical Redundancy Check (CRC) on downloaded ini file:
♦
♦
4.
Power down and then power up the device.
45.2.10.2
Automatic Update from Remote Servers
This example describes how to configure the Automatic Update feature where files are
stored and downloaded from different file server types. The example scenario includes the
following:
NFS server (Version 2) at 10.13.2.10 for storing the CPT file.
FTPS server at ftpserver.corp.com for storing the Feature Key file. The login
credentials to the server are username "root" and password "wheel".
Version 7.2
ini File:
AutoUpdateFrequency = 1440
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# update-frequency 1440
ini File:
AutoCmpFileUrl =
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# auto-firmware 'http://www.company.com/sw.cmp'
ini File:
CptFileURL =
'https://www.company.com/call_progress.dat'
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# call-progress-tones
'http://www.company.com/call_progress.dat'
ini File:
IniFileURL = 'https://www.company.com/config.ini'
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# voice-configuration
'http://www.company.com/config.ini'
ini File:
AUPDCheckIfIniChanged = 1
CLI:
# configure system
(config-system)# automatic update
(automatic-update)# crc-check regular
'https://www.company.com/sw.cmp'
789
Mediant 1000B Gateway & E-SBC
45. Automatic Provisioning