AudioCodes Mediant 1000 User Manual page 1155

User's Manual
Parameter
SBC-specific Parameters
Enable SBC
configure voip > application >
enable-sbc
[EnableSBCApplication]
SBC and CRP Parameters
Unclassified Calls
configure voip > sbc settings >
unclassified-calls
[AllowUnclassifiedCalls]
SBC Max Call Duration
configure voip > sbc settings > sbc-
mx-call-duration
[SBCMaxCallDuration]
SBC No Answer Timeout
configure voip > sbc settings > sbc-
no-arelt-timeout
[SBCAlertTimeout]
configure voip > sbc settings >
num-of-subscribes
[NumOfSubscribes]
Version 7.2
Enables the Session Border Control (SBC) application.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

In addition to enabling the parameter, the number of
maximum SBC/IP-to-IP sessions must be included in the
License Key.
Determines whether incoming calls that cannot be classified
(i.e. classification process fails) to a Source IP Group are
rejected or processed.

[0] Reject = (Default) Call is rejected if classification fails.

[1] Allow = If classification fails, the incoming packet is
assigned to a source IP Group (and subsequently
processed) as follows:

The source SRD is determined according to the SIP
Interface to where the SIP-initiating dialog request is
sent. The source IP Group is set to the default IP
Group associated with this SRD.

If the source SRD is ID 0, then source IP Group ID 0 is
chosen. In case of any other SRD, then the first IP
Group associated with this SRD is chosen as the
source IP Group or the call. If no IP Group is
associated with this SRD, the call is rejected.
Defines the maximum duration (in minutes) per SBC call
(global). If the duration is reached, the device terminates the
call.
The valid range is 0 to 35,791, where 0 is unlimited duration.
The default is 0.
Note: You can also configure this functionality per specific
calls, using IP Profiles (IpProfile_SBCMaxCallDuration). For a
detailed description of the parameter and for configuring this
functionality in the IP Profiles table, see ''Configuring IP
Profiles'' on page 393. If this functionality is configured for a
specific IP Profile, the settings of this global parameter is
ignored for calls associated with the IP Profile.
Defines the timeout (in seconds) for SBC outgoing (outbound
IP routing) SIP INVITE messages. If the called IP party does
not answer the call within this user-defined interval, the device
disconnects the session. The device starts the timeout count
upon receipt of a SIP 180 Ringing response from the called
party. If no other SIP response (for example, 200 OK) is
received thereafter within this timeout, the call is released.
The valid range is 0 to 3600 seconds. the default is 600.
Defines the maximum number of concurrent SIP SUBSCRIBE
sessions permitted on the device.
The valid value is any value between 0 and the maximum
1155
62. Configuration Parameters Reference
Description
Mediant 1000B Gateway & E-SBC