62.10.6 PSTN Parameters
This subsection describes the device's PSTN parameters.
62.10.6.1
General Parameters
The general PSTN parameters are described in the table below.
Parameter
Trunk Name
config-voip > interface
<e1|t1|bri> name
[DigitalPortInfo_x]
Protocol Type
configure voip > interface e1-
t1|bri > protocol
[ProtocolType]
User's Manual
Table 62-56: General PSTN Parameters
Defines an arbitrary name for a trunk (where x denotes the trunk
number for the ini file parameter). This can be used to help you
easily identify the trunk.
The valid value is a string of up to 40 characters. The following
special characters can be used (without the quotes):
" " (space)
"." (period)
"=" (equal sign)
"-" (hyphen)
"_" (underscore)
"#" (pound sign)
By default, the value is undefined.
Defines the PSTN protocol for all the Trunks. To configure the
protocol type for a specific Trunk, use the ini file parameter
ProtocolType_x:
[0] NONE
[1] E1 EURO ISDN = ISDN PRI Pan-European (CTR4)
protocol
[2] T1 CAS = Common T1 robbed bits protocols including E&M
wink start, E&M immediate start, E&M delay dial/start and loop-
start and ground start.
[3] T1 RAW CAS
[4] T1 TRANSPARENT = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 24 of all
trunks are mapped to DSP channels.
[5] E1 TRANSPARENT 31 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31 of each
trunk are mapped to DSP channels.
[6] E1 TRANSPARENT 30 = Transparent protocol, where no
signaling is provided by the device. Timeslots 1 to 31,
excluding time slot 16 of all trunks are mapped to DSP
channels.
[7] E1 MFCR2 = Common E1 MFC/R2 CAS protocols
(including line signaling and compelled register signaling).
[8] E1 CAS = Common E1 CAS protocols (including line
signaling and MF/DTMF address transfer).
[9] E1 RAW CAS
[10] T1 NI2 ISDN = National ISDN 2 PRI protocol
[11] T1 4ESS ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 4ESS switch.
[12] T1 5ESS 9 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-9 switch.
1074
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045