AudioCodes Mediant 1000 User Manual page 488

Parameter
Source IP Address
src-ip-address
[PstnPrefix_SourceAddress]
Source Phone Prefix
src-phone-prefix
[PstnPrefix_SourcePrefix]
Source Host Prefix
src-host-prefix
[PstnPrefix_SrcHostPrefix]
Destination Phone Prefix
dst-host-prefix
[PstnPrefix_DestHostPrefix]
User's Manual
Group in the 'Source IP Group' parameter (in this table) is
different, the incoming SIP call is rejected. If the 'Source IP
Group' parameter is not defined, the SIP Interface associated
with the default SRD (Index 0) is used. If there is no valid source
IP Group, the call is rejected.
Defines the source IP address of the incoming IP call.
The IP address can be configured in dotted-decimal notation
(e.g., 10.8.8.5) or as an FQDN. By default, no value is defined.
Note:

If the address is an FQDN, DNS resolution is done according
to the DNSQueryType parameter.

The source IP address is obtained from the Contact header in
the INVITE message.

You can configure from where the source IP address is
obtained, using the SourceIPAddressInput parameter.

The source IP address can include the following wildcards:

"x": denotes single digits. For example, 10.8.8.xx
represents all the addresses between 10.8.8.10 and
10.8.8.99.

"*": denotes any number between 0 and 255. For
example, 10.8.8.* represents all addresses between
10.8.8.0 and 10.8.8.255.
Defines the prefix or suffix of the calling (source) telephone
number.
The prefix can include up to 49 digits. You can use special
notations for denoting the prefix. For example, [100-
199](100,101,105) denotes a number that starts with 100 to 199
and ends with 100, 101 or 105. To denote any prefix, use the
asterisk (*) symbol. To denote calls without a calling number, use
the $ sign. For a description of available notations, see ''Dialing
Plan Notation for Routing and Manipulation Tables'' on page
923.
By default, no value is defined.
Note: If the P-Asserted-Identity header is present in the
incoming INVITE message, the value of the parameter is
compared to the P-Asserted-Identity URI host name (and not the
From header).
Defines the prefix of the URI host name in the From header of
the incoming INVITE message.
By default, no value is defined. To denote any prefix, use the
asterisk (*) wildcard.
Note: If the P-Asserted-Identity header is present in the
incoming INVITE message, the value of the parameter is
compared to the P-Asserted-Identity URI host name (and not the
From header).
Defines the prefix or suffix of the called (destined) telephone
number. You can use special notations for denoting the prefix.
For example, [100-199](100,101,105) denotes a number that
starts with 100 to 199 and ends with 100, 101 or 105. To denote
any prefix, use the asterisk (*) symbol or to denote calls without
a called number, use the $ sign. For a description of available
488
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045