AudioCodes Mediant 1000 User Manual page 1066

Parameter
[ResourcePriorityNetworkDomains] Defines up to 32 user-defined MLPP network domain names
Default Call Priority
dflt-call-prio
[SIPDefaultCallPriority]
User's Manual

[1] DSN (default)

[2] DOD

[3] DRSN

[5] UC

[7] CUC
Note:

If the ISDN message contains a Precedence IE, the device
automatically interworks the "network identity" digits in the IE
to the network domain subfield in the Resource-Priority
header. For more information, see Multilevel Precedence and
Preemption on page 561.

The parameter is applicable only to digital interfaces.
(namespaces). This value is used in the AS-SIP Resource-
Priority header of the outgoing SIP INVITE request. The
parameter is used in combination with the
MLPPDefaultNamespace parameter, where you need to enter
the table row index as its value.
The parameter is also used for mapping the Resource-Priority
field value of the SIP Resource-Priority header to the ISDN
Precedence Level IE. The mapping is configured by the field,
EnableIp2TelInterworking:

Disabled: The network-domain field in the Resource-Priority
header is set to "0 1 0 0" (i.e., "routine") in the Precedence
Level field.

Enabled: The network-domain field in the Resource-Priority
header is set in the Precedence Level field according to
Table 5.3.2.12-4 (Mapping of RPH r-priority Field to ISDN
Precedence Level Value).
The domain name can be a string of up to 10 characters.
The format of this table ini file parameter is as follows:
FORMAT ResourcePriorityNetworkDomains_Index =
ResourcePriorityNetworkDomains_Name,
ResourcePriorityNetworkDomains_EnableIp2TelInterworking;
ResourcePriorityNetworkDomains 1 = dsn, 0;
ResourcePriorityNetworkDomains 2 = dod, 0;
ResourcePriorityNetworkDomains 3 = drsn, 0;
ResourcePriorityNetworkDomains 5 = uc, 1;
ResourcePriorityNetworkDomains 7 = cuc, 0;
[ \ResourcePriorityNetworkDomains ]
Note:

Indices 1, 2, 3, 5, and 7 cannot be modified and are defined
for DSN, DOD, DRSN, UC, and CUC, respectively.

If the MLPPDefaultNamespace parameter is set to -1,
interworking from PSTN NI digits is done automatically.

The parameter is applicable only to digital interfaces.
Determines the default call priority for MLPP calls.

[0] 0 = (Default) ROUTINE

[2] 2 = PRIORITY

[4] 4 = IMMEDIATE
1066
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045