Using Dial Plan Tags For Outbound Manipulation - AudioCodes Mediant 1000 User Manual

User's Manual
3. Add an SBC IP-to-IP routing rule using the prefix tag to represent the different source
or destination URI user parts:
a. Open the IP-to-IP Routing table (see ''Configuring SBC IP-to-IP Routing Rules''
on page 656), and then click New.
b. Configure the prefix tag in the 'Source Username Prefix' or 'Destination
Username Prefix' fields (e.g., "LOCL", without the quotes).
c. Continue configuring the rule as required.
4. Configure a manipulation rule to remove the prefix tags before the device sends the
message to the destination:
a. Open the Outbound Manipulations table (see ''Configuring IP-to-IP Outbound
Manipulations'' on page 683), and then click New.
b. Configure matching characteristics for the incoming call (e.g., set 'Source IP
Group' to "1"), including calls with the prefix tag (in the 'Source Username Prefix'
or 'Destination Username Prefix' fields, enter the prefix tag to remove).
c. Configure the 'Remove from Left' or 'Remove from Right' fields (depending on
whether you added the tag at the beginning or end of the URI user part,
respectively), enter the number of characters making up the tag.
35.4

Using Dial Plan Tags for Outbound Manipulation

You can use Dial Plan tags to denote source and/or destination URI user names in
Outbound Manipulation rules in the Outbound Manipulations table.
The following procedure describes how to configure Outbound Manipulation based on tags.

To configure Outbound Manipulation based on tags:
1. In the Dial Plan table, configure a Dial Plan (see ''Configuring Dial Plans'' on page
689).
2. In the IP Group or SRD associated with the calls for which you want to use tag-based
routing, assign the Dial Plan that you configured in Step 1.
•
IP Groups table: 'Dial Plan' parameter (IPGroup_SBCDialPlanName) - see
''Configuring IP Groups'' on page 333
•
SRDs table: 'Dial Plan' parameter (SRD_SBCDialPlanName) - see ''Configuring
SRDs'' on page 317
3. In the Outbound Manipulations table (see ''Configuring IP-to-IP Outbound
Manipulations'' on page 683), configure a rule with the required manipulation and
whose matching characteristics include the tag(s) that you configured in your Dial Plan
in Step 1. The tags are assigned using the following parameters:
•
'Source Tags' parameter (IPOutboundManipulation_SrcTags): tag denoting the
calling users
•
'Destination Tags' parameter (IPOutboundManipulation_DestTags): tag denoting
the called users
Version 7.2 699 Mediant 1000B Gateway & E-SBC
35. Configuring Dial Plans