AudioCodes Mediant 1000 User Manual page 335

User's Manual
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Apply.
Parameter
SRD
srd-name
[IPGroup_SRDName]
General
Index
[IPGroup_Index]
Name
name
[IPGroup_Name]
Topology Location
topology-location
[IPGroup_TopologyLocation]
Type
type
[IPGroup_Type]
Version 7.2
Table 17-6: IP Groups Table Parameter Descriptions
Assigns an SRD to the IP Group.
If only one SRD is configured in the SRDs table, the SRD is assigned
by default. If multiple SRDs are configured in the SRDs table, no value
is assigned by default and you must assign one.
To configure SRDs, see Configuring SRDs on page 317.
Note:

The parameter is mandatory.

For the parameter to take effect, a device reset is required.
Defines an index for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 40 characters.
Note: Each row must be configured with a unique name.
Defines the display location of the IP Group in the Topology view.

[0] Down = (Default) The IP Group element is displayed on the
lower border of the view.

[1] Up = The IP Group element is displayed on the upper border of
the view.
For more information on the Topology view, see ''Building and Viewing
SIP Entities in Topology View'' on page 355.
Defines the type of IP Group:

[0] Server = Applicable when the destination address of the IP
Group (e.g., ITSP, Proxy, IP-PBX, or Application server) is known.
Description
335 Mediant 1000B Gateway & E-SBC
17. Control Network