AudioCodes Mediant 1000 User Manual page 508

Parameter
Action
Stripped Digits From Left
remove-from-left
[_RemoveFromLeft]
Stripped Digits From Right
remove-from-right
[RemoveFromRight]
Number of Digits to Leave
num-of-digits-to-leave
[LeaveFromRight]
Prefix to Add
prefix-to-add
[Prefix2Add]
Suffix to Add
suffix-to-add
[Suffix2Add]
TON
ton
[NumberType]
User's Manual
Defines the number of digits to remove from the left of the telephone
number prefix. For example, if you enter 3 and the phone number is
5551234, the new phone number is 1234.
Defines the number of digits to remove from the right of the telephone
number prefix. For example, if you enter 3 and the phone number is
5551234, the new phone number is 5551.
Defines the number of digits that you want to keep from the right of the
phone number. For example, if you enter 4 and the phone number is
00165751234, then the new number is 1234.
Defines the number or string that you want added to the front of the
telephone number. For example, if you enter 9 and the phone number
is 1234, the new number is 91234.
Defines the number or string that you want added to the end of the
telephone number. For example, if you enter 00 and the phone number
is 1234, the new number is 123400.
Defines the Type of Number (TON).

[0] Unknown (default)

[1] International-Level2 Regional

[2] National-Level1 Regional

[3] Network-PSTN Specific

[4] Subscriber-Level0 Regional

[6] Abbreviated
The applicable values depend on the NPI value:

If you select Unknown for NPI, you can select Unknown.

If you select Private for NPI, you can set TON to one of the
following:

Unknown

International-Level2 Regional

National-Level1 Regional

PISN Specific

Subscriber-Level0 Regional

If you select E.164 Public for NPI, you can set TON to one of the
following:

Unknown

International-Level2 Regional

National-Level1 Regional

Network-PSTN Specific

Subscriber-Level0 Regional

Abbreviated
Note:

The parameter is applicable only to the Destination Phone Number
Manipulation for IP-to-Tel Calls table and Source Phone Number
Manipulation for IP-to-Tel Calls table.

TON can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.

For more information on available NPI/TON values, see Numbering
508
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045