AudioCodes Mediant 1000 User Manual page 501

User's Manual
•
Analog interfaces: All FXS / FXO lines pertaining to a Trunk Group are busy or
unavailable
The following procedure describes how to configure Forward on Busy Trunks through the
Web interface. You can also configure it through ini file (ForwardOnBusyTrunkDest) or CLI
(configure voip > gateway routing fwd-on-bsy-trk-dst).

To configure a Forward on Busy Trunk Destination rule:
1. Open the Forward on Busy Trunk Destination table (Setup menu > Signaling &
Media tab > Gateway folder > Routing > Forward on Busy Trunk Destination).
2. Click New; the following dialog box appears:
Figure 23-14: Forward on Busy Trunk Destination Table - Add Dialog Box
The figure above displays a configuration that forwards IP-to-Tel calls destined for
Trunk Group ID 1 to destination IP address 10.13.5.67 if conditions mentioned earlier
exist.
3. Configure a rule according to the parameters described in the table below.
4. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Table 23-10: Forward on Busy Trunk Destination Parameter Descriptions
Parameter
Index
[ForwardOnBusyTrunkDest_Index]
Trunk Group ID
trunk-group-id
[ForwardOnBusyTrunkDest_TrunkGroupId]
Forward Destination
forward-dst
[ForwardOnBusyTrunkDest_ForwardDestination]
Version 7.2
Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique
index.
Defines the Trunk Group ID to which the IP call is
destined to.
Defines the alternative IP destination for the call
used if the Trunk Group is busy or unavailable.
The valid value can be an IP address in dotted-
decimal notation, an FQDN, or a SIP Request-URI
user name and host part (i.e., user@host). The
following syntax can also be used:
host:port;transport=xxx (i.e., IP address, port and
transport type).
Note:
•
If you do not specify a port, the device uses
UDP port 5060.
501 Mediant 1000B Gateway & E-SBC
23. Routing