Ntp And Daylight Saving Time Parameters - AudioCodes Mediant 1000 User Manual

Parameter
server option
[DhcpOption]
DHCP Static IP Table
DHCP Static IP table
configure network > dhcp-
server static-ip <index>
[DhcpStaticIP]

62.2.9 NTP and Daylight Saving Time Parameters

The Network Time Protocol (NTP) and daylight saving time parameters are described in
the table below.
Table 62-17: NTP and Daylight Saving Time Parameters
Parameter
NTP Parameters
CLI path: configure system > ntp >
Note: For more information on Network Time Protocol (NTP), see ''Simple Network Time Protocol
Support'' on page 119.
Primary NTP Server Address
primary-server
[NTPServerIP]
Secondary NTP Server
Address
secondary-server
[NTPSecondaryServerIP]
NTP Update Interval
update-interval
[NTPUpdateInterval]
NTP Authentication Key
User's Manual
The format of the ini file table parameter is as follows:
[ DhcpOption ]
FORMAT DhcpOption_Index = DhcpOption_DhcpServerIndex,
DhcpOption_Option, DhcpOption_Type, DhcpOption_Value,
DhcpOption_ExpandValue;
[ \DhcpOption ]
For a detailed description of the table, see Configuring Additional DHCP
Options on page 217.
Defines static "reserved" IP addresses that the device's DHCP server
allocates to specific DHCP clients defined by MAC address.
The format of the ini file table parameter is as follows:
[ DhcpStaticIP ]
FORMAT DhcpStaticIP_Index = DhcpStaticIP_DhcpServerIndex,
DhcpStaticIP_IPAddress, DhcpStaticIP_MACAddress;
[ \DhcpStaticIP ]
For a detailed description of the table, see Configuring Static IP
Addresses for DHCP Clients on page 219.
Defines the IP address (in dotted-decimal notation or as an FQDN) of
the NTP server. The advantage of using an FQDN is that multiple IP
addresses can be resolved from the DNS server, providing NTP
server redundancy.
The default IP address is 0.0.0.0 (i.e., internal NTP client is disabled).
Defines a second NTP server's address as an FQDN or an IP address
(in dotted-decimal notation). This NTP is used for redundancy; if the
primary NTP server fails, then this NTP server is used.
The default IP address is 0.0.0.0.
Defines the time interval (in seconds) that the NTP client requests for
a time update.
The default interval is 86400 (i.e., 24 hours). The range is 0 to
214783647.
Note: It is not recommend to set the parameter to beyond one month
(i.e., 2592000 seconds).
Defines the NTP authentication key identifier for authenticating NTP
messages. The identifier must match the value configured on the NTP
950
Mediant 1000B Gateway & E-SBC
Description
Description
Document #: LTRT-27045