Configuring Tel Profile - AudioCodes Mediant 1000 User Manual

19.5

Configuring Tel Profile

The Tel Profiles table lets you configure up to nine Tel Profiles. A Tel Profile is a set of
parameters with specific settings which can be assigned to specific calls. The Tel Profiles
table includes a wide range of parameters for configuring the Tel Profile. Each of these
parameters has a corresponding "global" parameter, which when configured applies to all
calls. The main difference, if any, between the Tel Profile parameters and their
corresponding global parameters are their default values.
Tel Profiles provide high-level adaptation when the device interworks between different
equipment and protocols (at both the Tel and IP sides), each of which may require different
handling by the device. For example, if specific channels require the use of the G.711
coder, you can configure a Tel Profile with this coder and assign it to these channels.
To use your Tel Profile for specific calls, you need to assign it to specific channels (trunks)
in the Trunk Group table (see Configuring Trunk Groups on page 465)).
The following procedure describes how to configure Tel Profiles through the Web interface.
You can also configure it through ini file (TelProfile) or CLI (configure voip/coders-and-
profiles tel-profile).

To configure a Tel Profile:
1. Open the Tel Profiles table (Setup menu > Signaling & Media tab > Coders &
Profiles folder > Tel Profiles).
2. Click New; the following dialog box appears:
3. Configure a Tel Profile according to the parameters described in the table below. For a
description of each parameter, refer to the corresponding "global" parameter.
4. Click Apply.
Table 19-6: Tel Profile Table Parameters and Corresponding Global Parameters
Tel Profile Parameter
General
Index
[TelProfile_Index]
Name
profile-name
User's Manual
Figure 19-7: Tel Profiles Table - Add Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
Mediant 1000B Gateway & E-SBC
Global Parameter
428 Document #: LTRT-27045