AudioCodes Mediant 1000 User Manual page 907

User's Manual
Parameter
IP Group
ip-group-id
[Test_Call_IPGroupName]
Destination Address
dst-address
[Test_Call_DestAddress]
SIP Interface
sip-interface-name
[Test_Call_SIPInterfaceName]
Application Type
application-type
[Test_Call_ApplicationType]
Destination Transport Type
dst-transport
[Test_Call_DestTransportType]
Version 7.2

[1] IP Group = (Default) Calls are matched by (or routed to) an IP
Group. To specify the IP Group, see the 'IP Group' parameter in
the table.

[2] Dest Address = Calls are matched by (or routed to) a
destination IP address. To configure the address, see the
'Destination Address' parameter in the table.
Note:

If configured to Tel-to-IP or Dest Address, you must assign a
SIP Interface (see the 'SIP Interface' parameter in the table).

For REGISTER messages:

The Tel-to-IP option cannot be used as the routing method.

If configured to IP Group, only Server-type IP Groups can
be used.
Assigns an IP Group. This is the IP Group that the test call is sent to
or received from.
By default, no value is defined.
To configure IP Groups, see ''Configuring IP Groups'' on page 333.
Note:

The parameter is applicable only if you configure the 'Route By'
parameter to IP Group.

The IP Group is used for incoming and outgoing calls.
Defines the destination host.
The valid value is an IP address[:port] or DNS name[:port].
Note: The parameter is applicable only if the 'Route By' parameter
is configured to Dest Address [2].
Assigns a SIP Interface. This is the SIP Interface to which the test
call is sent and received from.
By default, no value is defined.
To configure SIP Interfaces, see Configuring SIP Interfaces on page
326.
Note: The parameter is applicable only if the 'Route By' parameter
is configured to Tel-to-IP or Dest Address.
Defines the application type for the endpoint. This associates the IP
Group and SRD to a specific SIP interface. For example, assume
two SIP Interfaces are configured in the SIP Interfaces table where
one is set to "GW" and one to "SBC" for the 'Application Type'. If the
parameter is set to "SBC", the device uses the SIP Interface set to
"SBC".

[0] GW (default) = Gateway application

[2] SBC = SBC application
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: The parameter is applicable only if the 'Route By' parameter
907
59. Testing SIP Signaling Calls
Description
Mediant 1000B Gateway & E-SBC