Viewing Gateway Cdr History - AudioCodes Mediant 1000 User Manual

51.6

Viewing Gateway CDR History

You can view historical (last 4,096 CDRs) Call Detail Records (CDR) of Gateway calls in a
table. CDR history information is stored on the device's memory. When a new CDR is
generated, the device adds it to the top of the table and all existing entries are shifted one
down in the table. If the table has reached maximum capacity of entries and a new CDR is
added, the last CDR entry is removed from the table.
Note: If the device is reset, all CDRs are deleted from memory and from the table.

To view Gateway CDR history:

Web: Open the Gateway CDR History table (Monitor menu > Monitor tab > VoIP
Status folder > Gateway CDR History).

CLI:
•
All CDR history:
# show voip calls history gw
•
CDR history for a specific SIP session ID:
# show voip calls history gw <session ID>
Field
Call End Time
End Point
Caller
Callee
Direction
Remote IP
User's Manual
Figure 51-5: Gateway CDR History Table
Table 51-6: Gateway CDR History Table
Displays the time at which the call ended. The time is displayed in the
format, hh:mm:ss, where hh is the hour, mm the minutes and ss the
seconds (e.g., 15:06:36).
Displays the device's endpoint involved in the call, displayed in the
format:

Analog: <interface>-<module>/<port>. For example, "FXS-3/1"
denotes FXS module 3, port 1.

Digital: <interface>-<module>/<Trunk ID>/<B-channel>. For example,
"ISDN-1/2/3" denotes ISDN module 1, Trunk ID 2, B-channel 3.
Displays the phone number (source number) of the party who made the
call.
Displays the phone number (destination number) of the party to whom
the call was made.
Displays the direction of the call with regards to IP and Tel sides:

"Incoming": IP-to-Tel call

"Outgoing": Tel-to-IP call
Displays the IP address of the call party. For an "Incoming" call, this is
the source IP address; for an "Outgoing" call, this is the destination IP
828
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045