AudioCodes Mediant 1000 User Manual page 1048

Parameter
Enable Caller ID
configure voip > gateway dtmf-
supp-service supp-service-settings
> enable-caller-id
[EnableCallerID]
Caller ID Type
configure voip > gateway dtmf-
supp-service supp-service-settings
> ccaller-ID-type
[CallerIDType]
User's Manual
CallerDisplayInfo_IsCidRestricted, CallerDisplayInfo_Module,
CallerDisplayInfo_Port;
[\CallerDisplayInfo]
Where,

Module = Module number, where 1 denotes the module in
Slot 1.

Port = Port number, where 1 denotes Port 1 of a module.
For example:
CallerDisplayInfo 0 = Susan C.,0,1,1;
the Caller ID for Port 1 of Module 1)
CallerDisplayInfo 1 = Mark M.,0,1,2;
Caller ID for Port 2 of Module 1)
For a detailed description of the table, see Configuring Caller
Display Information on page 582.
Note:

The indexing of this table ini file parameter starts at 0.

The parameter is applicable only to analog interfaces.
Global parameter that enables Caller ID.

[0] Disable (default)

[1] Enable =

FXS: The calling number and display text (from IP) are
sent to the device's port.

FXO or CAS: The device detects the Caller ID signal
received from the Tel and sends it to the IP in the SIP
INVITE message (as the 'Display' element).
To configure the Caller ID string per port, see Configuring Caller
Display Information on page 582. To enable or disable caller ID
generation / detection per port, see Configuring Caller ID
Permissions on page 586.
Determines the standard used for detection (FXO) and
generation (FXS) of Caller ID, and detection (FXO) / generation
(FXS) of MWI (when specified) signals:

[0] Standard Bellcore = (Default) Caller ID and MWI

[1] Standard ETSI = Caller ID and MWI

[2] Standard NTT

[4] Standard BT = Britain

[16] Standard DTMF Based ETSI

[17] Standard Denmark = Caller ID and MWI

[18] Standard India

[19] Standard Brazil
Note:

The parameter is applicable only to analog interfaces.

Typically, the Caller ID signals are generated / detected
between the first and second rings. However, sometimes the
Caller ID is detected before the first ring signal. In such a
scenario, set the RingsBeforeCallerID parameter to 0.

Caller ID detection for Britain [4] is not supported on the
device's FXO ports. Only FXS ports can generate the Britain
[4] Caller ID.

To select the Bellcore Caller ID sub standard, use the
1048
Mediant 1000B Gateway & E-SBC
Description
("Susan C." is sent as
("Mark M." is sent as
Document #: LTRT-27045