Telnet Parameters - AudioCodes Mediant 1000 User Manual

Parameter
[WelcomeMessage]

62.1.3 Telnet Parameters

The Telnet parameters are described in the table below.
Parameter
Embedded Telnet Server
configure system > cli-
settings > telnet
User's Manual
required.

You cannot reset the username and password through
the Web interface (by loading an ini file or on the
AdminPage). To reset the username and password:


SNMP:
1) Set acSysGenericINILine to
WEBPasswordControlViaSNMP = 1, and reset the
device with a flash burn (set
acSysActionSetResetControl to 1 and
acSysActionSetReset to 1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following
format:
Username acSysWEBAccessUserName:
old/pass/new
Password acSysWEBAccessUserCode:
username/old/new
Enables and defines a Welcome message that appears on
the Web Login page for logging in to the Web interface.
The format of the ini file table parameter is:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index =
WelcomeMessage_Text
[\WelcomeMessage]
For Example:
FORMAT WelcomeMessage_Index =
WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message
***" ;
WelcomeMessage 3 = "**********************************" ;
Note:

Each index row represents a line of text in the Welcome
message box. Up to 20 lines (or rows) of text can be
defined.

The configured text message must be enclosed in double
quotation marks (i.e., "...").

If the parameter is not configured, no Welcome message
is displayed.
Table 62-3: Telnet Parameters
Enables the device's embedded Telnet server. Telnet is disabled by
default for security.

[0] Disable
930
Mediant 1000B Gateway & E-SBC
Description
Description
Document #: LTRT-27045