Configuring Remote Http Hosts - AudioCodes Mediant 1000 User Manual

User's Manual

15.5.1.1 Configuring Remote HTTP Hosts

The HTTP Remote Hosts table lets you configure up to 10 remote HTTP hosts per Remote
Web Service. The HTTP Remote Hosts table is a "child" of the Remote Web Services table
(configured in ''Configuring Remote Web Services'' on page 262).
The following procedure describes how to configure HTTP Remote hosts through the Web
interface. You can also configure it through ini file (HTTPRemoteServices) or CLI
(configure system > http-services > http-remote-hosts).

To configure a remote HTTP host:
1. Open the Remote Web Services table (Setup menu > IP Network tab > Web
Services folder > Remote Web Services).
2. In the table, select the required remote Web service index row, and then click the
HTTP Remote Hosts link located below the table; the HTTP Remote Hosts table
appears.
3. Click New; the following dialog box appears:
Figure 15-41: HTTP Remote Hosts Table - Add Dialog Box
4. Configure an HTTP remote host according to the parameters described in the table
below.
5. Click Apply, and then save your settings to flash memory.
Table 15-19: HTTP Remote Hosts Table Parameter Descriptions
Parameter
Index
rest-servers
[HTTPRemoteHosts_RemoteHostindex]
Name
[HTTPRemoteHosts_Name]
Version 7.2
Defines an index number for the new table row.
Note:

Each row must be configured with a unique index.

The parameter is mandatory.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 40 characters. By
default, no value is defined.
267
Description
Mediant 1000B Gateway & E-SBC
15. Services