AudioCodes Mediant 1000 User Manual page 277

User's Manual
Proxy Services'' on page 275). You can configure up to 50 HTTP Proxy hosts; up to 5
HTTP Proxy hosts per HTTP Proxy Service.
The following procedure describes how to configure HTTP Remote hosts through the Web
interface. You can also configure it through ini file (HTTPProxyHost) or CLI (configure
network > http-proxy http-proxy-host).

To configure an HTTP Proxy Host:
1. Open the HTTP Proxy Services table (Setup menu > IP Network tab > HTTP Proxy
folder > HTTP Proxy Services).
2. In the table, select the required HTTP Proxy Service index row, and then click the
HTTP Proxy Hosts link located below the table; the HTTP Proxy Hosts table appears.
3. Click New; the following dialog box appears:
Figure 15-50: HTTP Proxy Hosts Table - Add Dialog Box
4. Configure an HTTP Proxy Host according to the parameters described in the table
below.
5. Click Apply, and then save your settings to flash memory.
Table 15-22: HTTP Proxy Hosts Table Parameter Descriptions
Parameter
General
Index
Network Interface
network-interface
[HTTPProxyHost_NetworkInterface]
Proxy Address
proxy-address
[HTTPProxyHost_IpAddress]
Version 7.2
Defines an index number for the new table row.
Note:

Each row must be configured with a unique index.

The parameter is mandatory.
Assigns a local, network interface to the HTTP Proxy Host.
By default, no value is defined.
To configure network interfaces, see ''Configuring IP Network
Interfaces'' on page 135.
Note: The parameter is mandatory.
Defines the address of the managed equipment (host).
The valid value is an IP address in dotted-decimal notation or
an FQDN (up to 100 characters). If the address is an FQDN,
the device uses DNS to resolve it into an IP address. If the DNS
277
Description
Mediant 1000B Gateway & E-SBC
15. Services