Basic Maintenance; Resetting The Device - AudioCodes Mediant 1000 User Manual

User's Manual
40

Basic Maintenance

This section describes basic maintenance procedures.
40.1

Resetting the Device

You can reset the device through the device's management tools. Device reset may be
required for maintenance purposes. Certain parameters require a device reset for their
settings to take effect. These parameters are displayed in the Web interface with the
lightning
reset, the Reset button on the Web interface's toolbar is displayed with a red border, as
shown below:
The Web interface also provides you with the following options when resetting the device:

Save current configuration to the device's flash memory (non-volatile) prior to reset

Reset the device only after a user-defined time (Graceful Shutdown) to allow current
calls to end (calls are terminated after this interval)
To reset the device (and save configuration to flash) through CLI, use the following
command:
# reset now

To reset the device through Web interface:
1. Open the Maintenance Actions page:
•
Toolbar: Click the Reset button.
•
Navigation tree: Setup menu > Administration tab > Maintenance folder >
Maintenance Actions.
2. From the 'Save To Flash' drop-down list, select one of the following:
•
Yes: Current configuration is saved (burned) to flash memory prior to reset
(default).
•
No: The device resets without saving the current configuration to flash. All
configuration done after the last configuration save will be discarded (lost) after
reset.
3. From the 'Graceful Option' drop-down list, select one of the following:
•
Yes: Reset starts only after a user-defined time, configured in the 'Shutdown
Timeout' field (see next step). During this interval, no new traffic is accepted. If no
traffic exists and the time has not yet expired, the device resets immediately.
•
No: Reset begins immediately, regardless of traffic. Any existing traffic is
immediately terminated.
Version 7.2
symbol. In addition, whenever you do any configuration change that requires a
Figure 40-1: Resetting the Device
727 Mediant 1000B Gateway & E-SBC
40. Basic Maintenance