AudioCodes Mediant 1000 User Manual page 344

Parameter
Outbound Message
Manipulation Set
outbound-mesg-
manipulation-set
[IPGroup_OutboundManSet]
Message Manipulation User-
Defined String 1
msg-man-user-defined-
string1
[IPGroup_MsgManUserDef1
]
Message Manipulation User-
Defined String 2
msg-man-user-defined-
string2
[IPGroup_MsgManUserDef2
]
SBC Registration and Authentication
Max. Number of Registered
Users
max-num-of-reg-users
[IPGroup_MaxNumOfRegUs
ers]
Registration Mode
registration-mode
[IPGroup_RegistrationMode]
Authentication Mode
authentication-mode
[IPGroup_AuthenticationMod
e]
User's Manual
Manipulation Set (see the IPGroup_OutboundManSet parameter),
when the IP Group is the destination of the call.
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 368.
Note: If you assign a Message Manipulation Set ID that includes rules
for manipulating the host name in the Request-URI, To, and/or From
SIP headers, the parameter overrides the IPGroup_SIPGroupName
parameter.
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by
using the following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By default, no value
is defined.
To configure Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 368.
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by
using the following syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters. By default, no value
is defined.
To configure Message Manipulation rules, see ''Configuring SIP
Message Manipulation'' on page 368.
Defines the maximum number of users in this IP Group that can
register with the device.
The default is -1, meaning that no limitation exists for registered users.
Note: The parameter is applicable only to User-type IP Groups.
Defines the registration mode for the IP Group:

[0] User Initiates Registration (default)

[1] SBC Initiates Registration = Used when the device serves as a
client (e.g., with an IP PBX). This functions only with the User Info
file.

[2] Registrations not Needed = The device adds users to its
database in active state.
Defines the authentication mode.

[0] User Authenticates = (Default) The device does not handle the
authentication, but simply forwards the authentication messages
between the SIP user agents.

[1] SBC as Client = The device authenticates as a client. It receives
the 401/407 response from the proxy requesting for authentication.
The device sends the proxy the authorization credentials (i.e.,
344
Mediant 1000B Gateway & E-SBC
Description
Document #: LTRT-27045