VLAN classification configuration
Creating protocol VLAN classification rules
After you have defined protocol rules, you can apply those rules to an interface.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To apply a protocol-based classification rule to the selected interface, enter:
Creating IPv4 VLAN classification rules
In the case of an IPv4 subnet-based classification rule, the rule can be assigned to an interface
prior to the creation of the rule definition.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To apply a subnet-based classification rule to the selected interface, enter:
Deleting VLAN classification rules from an interface
Use the procedures in this section to remove VLAN classification rules from an interface.
Deleting protocol rules from an interface
Use the procedure in this section to delete a protocol-based VLAN classification rule from an
interface.
124
Configuration — Layer 2 Ethernet
configure terminal
interface ethernet <slot/port>
vlan classification protocol rule <id> vlan <vid>
configure terminal
interface ethernet <slot/port>
vlan classification ipv4
Comments? infodev@avaya.com
July 2013