Keithley 6220 Reference Manual page 272

10-8 Remote Operations
Table 10-2 (cont.)
Remote interface configuration commands
Ethernet interface commands (6221 only):
SYSTem:COMMunicate:ETHernet:ADDRess <string> Sets IP address of 6221.
SYSTem:COMMunicate:ETHernet:MASK <string>
SYSTem:COMMunicate:ETHernet:GATeway <string> Sets Ethernet gateway of 6221.
SYSTem:COMMunicate:ETHernet:DHCP <b>
SYSTem:COMMunicate:ETHernet:MAC?
SYSTem:COMMunicate:ETHernet:SAVE
Password commands:
SYSTem:PASSword[:CENable] <string>
SYSTem:PASSword:CDISable <string>
SYSTem:PASSword:ENABle <b>
SYSTem:PASSword:STATe?
SYSTem:PASSword:NEW <string>
1. SYST:COMM:SEL <name>
This command selects the interface: SERial, GPIB, or ETHernet (6221 only).
The Model 622x will perform a power-on reset when the interface is changed.
2. SYST:COMM:GPIB:ADDR <NRf>
This command sets the GPIB primary address (0-30, default 12). You must be
using the GPIB as the communication interface, or this command is ignored.
Note that address 21 is often used as a controller address, so 21 should be
avoided.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Command
Return to
Model 6220/6221 Reference Manual
<string> = "n.n.n.n"
Sets subnet mask of 6221.
<string> = "n.n.n.n"
<string> = "n.n.n.n"
Enables/disables DHCP.
<b> = ON or OFF
Queries 6221 MAC address.
Saves Ethernet setting changes.
Sends password to enable protected
commands.
<string> = "password"
Disables protected commands.
<string> = "password"
Enables/disables use of password.
<b> = ON or OFF
Queries protected command state.
0 = disabled; 1 = enabled
Sets new password.
<string> = "password"
' Select interface.
' Set GPIB primary address.
Section 10 topics
Description
10
11
12
13
14
15
16
17
18
19
20