Model 6220/6221 Reference Manual
NOTE
Setting source and compliance
Source and compliance editing from the front panel cannot be performed from the
front panel if the Model 622x is in remote. To return to the local state, press the
LOCAL key.
For remote programming, commands to select source range and set source and
compliance values are documented in
provided in the procedure for
Source and compliance editing
Figure 3-3
Figure 3-4
procedure to set source and compliance values for the Model 6221 follow
"Source/compliance editing
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
After calculating settling time (ST), compare it to
the published settling time specification in
Appendix
A. The larger of the two settling times
will apply.
"Sourcing current," on page
shows how to set source and compliance values for the Model 6220.
shows the source and compliance editing controls for the Model 6221. The
notes" for both procedures are provided on
Return to
Section 3 topics
DC Current Source Operation
Table
3-2. Programming examples are also
3-14.
3-9
Figure
3-4.
page
3-11.