Storing Readings; Recall - Keithley 6220 Reference Manual

6-14 Averaging Filter, Math, and Buffer

Storing readings

For front panel operation, the buffer is always active (enabled), and post-math
readings are automatically stored in the buffer.
For remote programming, buffer feed can be pre-math readings or post-math
readings, or the buffer can be disabled.
The buffer commands are documented in
onstrates a simple command sequence to configure the buffer.
Example – Configure the buffer to store pre-math delta readings. Storage will
start when Delta, Pulse Delta, or Differential Conductance is started.
TRACe:CLE
TRACe:FEED SENS1
TRACe:FEED:CONTrol NEXT ' Enable buffer.

Recall

For front panel operation, perform the following steps to view stored readings
and buffer statistics:
1.
2.
NOTE
3.
4.
NOTE
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Press RECALL. The reading stored in buffer location 0 will be displayed
along with the current source value and the timestamp.
As shown in Figure 6-3, use the edit keys to navigate through the buffer to
view stored readings.
For front panel operation, compliance is not indicated for
buffer readings. For remote programming, the compli-
ance state (in or out) for each reading is returned if the
COMP (compliance) data element is enabled. For details
on data elements, see
page 13-4.
To view buffer statistics, use the EDIT/LOCAL key. Each press of this key
displays the next statistic. After the last statistic is displayed (Std Dev),
pressing EDIT/LOCAL will display the stored readings.
When finished, press EXIT to return to the normal display.
The buffer can be cleared by pressing the CONFIG key
and then the RECALL key. With the "CLEAR BUFFER?"
message displayed, select YES.
Return to
Model 6220/6221 Reference Manual
Table 6-4. The following example dem-
' Clear buffer of readings.
' Set buffer feed for pre-math delta readings.
"FORMat subsystem," on
Section 6 topics