Keithley 6220 Reference Manual page 248

8-12 Triggering
12. TRIG:DIR <name>
This command enables (SOURce) or disables (ACCeptor) the TRIG source
bypass.
13. TRIG:ILIN <NRf>
This command selects the TRIG layer input signal line: 1, 2, 3, 4, 5, or 6.
14. TRIG:OLIN <NRf>
This command selects the TRIG layer input signal line: 1, 2, 3, 4, 5, or 6. Note
that for the Model 6221 only, the TRIG output line and phase marker
(SOUR:WAVE:PMAR:OLIN) lines cannot be the same, or a -221 Settings
Conflict error will occur. (See
15. TRIG:OUTP <name>
This command selects when to output the TRIG layer TRIG. Available selec-
tions include SOURce[1] (output after source), DELay (output after sweep
delay), or NONE (disabled).
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
' Set TRIG source bypass.
' Set TRIG layer TRIG input line.
' Set TRIG layer TRIG output line.
"Phase marker," on page
' Select when to output trigger.
Return to Section 8 topics
Model 6220/6221 Reference Manual
7-9).