Figure 18: Ln2600 Router Cable Management System; Figure 19: Ln2600 Router Cable Management System With Interface And Power; Cables - Juniper LN2600 Manual

LN2600 Rugged Security Router
54
Place the cables in the grooves present on the cable management system, and secure
3.
them with the respective cable clips.
NOTE: When using copper cables for SFPs, do not lay the cables in the
grooves present on the cable management system. Instead, just hold all
the cables together neatly at one place and secure it with a cable tie.
Figure 18 on page 54 shows the cable management system without the interface and
power cables plugged in to the router.

Figure 18: LN2600 Router Cable Management System

1— Cable grooves
2— Cable clip
3—Cable tie
Each interface port on the front of the LN2600 router has a corresponding cable
groove on the cable management system. Insert and secure the SFPs to the cable
management tray starting from the port labeled
the last port labeled 7 .
Figure 19 on page 54 shows the final placement of the interface cables in the cable
management system. Colors used in
Figure 19: LN2600 Router Cable Management System with Interface and Power Cables
1— USB
2— Gigabit Ethernet SFPs
3— RJ-45 console cable
At the exit point, hold all the interface cables at one place with a cable tie.
4.
4— Interface cable entrance
5— Power cable entrance
, and gradually proceeding toward
0
Figure 19 on page 54 are just for clarity.
4— DC power cables
5— Interface cable entrance
6— Power cable entrance
Copyright © 2018, Juniper Networks, Inc.