Installing The Mx480 Router Cable Management Bracket - Juniper MX480 Hardware Manual

251
Figure 72: Reinstalling an FPC
M X4 80

Installing the MX480 Router Cable Management Bracket

The cable management brackets attach to both sides of the router. To install the cable management
brackets (see Figure 73 on page 252):
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Position the cable management brackets on the front sides of the chassis.
3. Insert the tabs into the slots.
4. Tighten the captive screws completely.