Stabiliser Bar; Drive Wheels - Otto Bock Start M4 XXL Instructions For Use Manual

Removing/installing the push handles
1) Release the clamping lever (see fig. 39, item 1).
2) Push in the tripod spring (see fig. 39, item 2) and pull the push handle up and out of the adapter (see fig. 39,
item 3).
3) To install, push in the tripod spring again and insert the push handle into the adapter.
4) Firmly close the clamping lever (see fig. 39, item 1).
→ Both push handles must be installed at the same height.
39

7.8 Stabiliser bar

The stabiliser bar between the push handles increases the wheelchair's stability, especially in case of high loads
(see fig. 40). It has to be opened before folding the wheelchair.
Opening the stabiliser bar
1) Open the star handle on the right side (see fig. 41, item 1).
2) Fold the stabiliser bar down (see fig. 41, item 2).
Closing the stabiliser bar
1) Fold the stabiliser bar up until the opening is against the screw of the star handle.
2) Hand-tighten the star handle.
40

7.9 Drive wheels

WARNING
Improper assembly of removable wheels
Tipping, falling over of the user due to wheels coming off
► After each assembly, verify the proper fit of the removable wheels. The quick-release axles must be firmly
locked in the wheel attachment.
Start M4 XXL, Start M6 Junior
41
Use
25