Table of Contents
Advertisement
▼ To Disable Line Card Standby Power
●
To disable standby power on a line card, type this command:
# disablestby lc slot
where slot is the slot number of the line card from
▼ To Fully Power On Line Cards
●
To bring a line card to full power, type this command:
# activate lc slot
where slot is the slot number of the line card from
When a line card is activated, the Active LED is illuminated and the line card
goes to full power.
▼ To Power Down Line Cards to a Standby State
●
To power down a line card to a standby state, type this command:
# deactivate lc slot
where slot is the slot number of the line card from
When a line card is deactivated, the Active LED turns off, but the Standby LED
remains flashing.
80
Sun Datacenter Switch 3456 Installation Guide • December 2008
.
TABLE 9-1
.
TABLE 9-1
.
TABLE 9-1
Advertisement
Table of Contents
Need help?
Do you have a question about the Datacenter Switch 3456 and is the answer not in the manual?