Preparing Power Supplies; To Attach Power Cables - Sun Microsystems Datacenter Switch 3456 Installation Manual

Preparing Power Supplies

▼ To Attach Power Cables

The power cables for the Sun Datacenter Switch 3456 ship separately and are specific
to the country of installation. The facility power receptacles for the power cables
should be located such that the power cables are routed out of the way, either to the
sides of the chassis or under the floor.
1. Ensure that the circuit breakers for the power supplies are switched off.
2. Plug a power cable into each power supply.
See .
FIGURE 10-3
Plugging In the Power Cables
FIGURE 10-3
3. Route each power cable to its respective facility power receptacle.
4. Plug each power cable into the receptacle.
5. Energize the circuit breakers so that the power receptacles are live.
Chapter 10 Powering On 85