Summary of Contents for Sun Microsystems StorEdge Network 2 Gb McDATA Sphereon 4300 Switch FRU
Page 1
™ Sun StorEdge Network 2 Gb McDATA Sphereon 4300 Switch FRU Installation Note – Read this document before you install the field-replaceable unit (FRU). Caution – Before you install this Sun StorEdge 2 Gb McDATA Sphereon 4300 Switch FRU, use the following procedure to confirm that the firmware version of the FRU matches the firmware version of the Sun StorEdge 2 Gb McDATA Sphereon 4300 Switch (hereafter referred to as the “4300 switch”) it is replacing.
Page 2
To Confirm the Compatibility Between the Existing 4300 Switch Firmware and the 4300 Switch FRU Firmware 1. Telnet to the 4300 switch. a. If required, connect an Ethernet cable between the 4300 switch and your workstation (the host). b. Open a command-line window. c.
Page 3
To Remove and Replace the 4300 Switch Refer to the McDATA Sphereon 4300 Switch Installation and Service Manual, 620-000171. This manual is on the product CD. Caution – You must check and update the firmware version before you connect the 4300 switch to the network. To Check the New 4300 Switch Firmware Version 1.
Page 4
Sun suppliers. Portions may be derived from Berkeley BSD systems, licensed from U. of CA. Sun, Sun Microsystems, the Sun logo, Sun StorEdge, and Solaris are trademarks or registered trademarks of Sun Microsystems, Inc. in the U.S. and in other countries. All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International, Inc.
Need help?
Do you have a question about the StorEdge Network 2 Gb McDATA Sphereon 4300 Switch FRU and is the answer not in the manual?
Questions and answers