Jump To End - Mitsubishi Electric MELSEC-Q/L Programming Manual

Hide thumbs Also See for MELSEC-Q/L:

Table of Contents

Jump to END

Internal device

Processing details

• Jumps to the FEND or END instruction in the same program file.

Operation error

• In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into SD0.

Error details

After the FOR instruction was executed, the GOEND instruction was

executed prior to the NEXT instruction.

After the CALL, ECALL instruction was executed, the GOEND instruction

was executed prior to the the RET instruction.

During an interrupt program, the GOEND instruction was executed prior to

the IRET instruction.

The GOEND instruction was executed during the CHKCIR to CHKEND

instruction execution.

The GOEND instruction was executed during the IX to IXEND instruction

Program example

• The following program jumps to the END instruction if D0 holds a negative number.

[Ladder Mode]

6 BASIC INSTRUCTIONS

6.5 Program Branch Instructions

Redundant Universal