FX
/FX
/FX
3S
3G
3GC
Built-in Positioning Functions
• When two wires are connected to one terminal
6.8mm(0.27")
6.8mm(0.27")
3.2
European Terminal Board
The European terminal board is used for the high-speed output special adapter and the FX
output extension block.
3.2.1
Cable
Applicable cables and tightening torques
Single-wire
2-wires
Rod
terminal
with
insulation
sleeve
*1.
*2.
3.2.2
Termination of Cable End
Treat the ends of stranded wires and solid wires without coating or using bar terminals with insulating sleeve.
Tighten the terminals to a torque of 0.22 to 0.25 Nm.
Do not tighten terminal screws with a torque outside the above-mentioned range. Failure to do so may cause
equipment failures
or malfunctions.
• Directly terminate the end of the stranded/single-wire cable:
- Terminate the end of the stranded cable so that "barbed wires"
cannot protrude.
- Do not solder-plate the end of the cable.
• Terminate the cable end using a rod terminal with insulation sleeve:
If the cable sheath is too thick, it may be difficult to insert the cable
into the insulation sleeve. For this reason, select an appropriate cable
while referring to the external view.
<Reference>
Phoenix Contact
*3.
*4.
B - 44
Downloaded from
ManualsNet.com
/FX
/FX
PLC User's Manual - Positioning Control Edition
3U
3UC
3.7(0.15")
or less
6.0mm(0.24")
or more
3.7(0.15")
or less
6.0mm(0.24")
or more
Wire size (stranded/
single wire)
2
2
0.3 mm
to 0.5 mm
(AWG22 to 20)
2
(AWG22) 2
0.3 mm
2
2
0.3 mm
to 0.5 mm
(AWG22-20)
(Refer to the external
view of the rod terminal
shown in the following
figure.)
Old model name: CRIMPFOX ZA 3
Old model name: CRIMPFOX UD 6
Manufacturer
Model names
AI 0.5-8WH
Old model name: CRIMPFOX ZA 3
Old model name: CRIMPFOX UD 6
search engine
3 Connection of Input/Output Lines and Tightening Torques
Terminal
screw
Terminal
Tightening
torque
• To connect a stranded cable, peel the sheath off the cable,
and then twist the core before connection.
• To connect a single-wire cable, just peel the sheath off the
cable before connection.
• Rod terminal with insulation sleeve
0.22 to
(recommended terminal)
0.25 N
m
AI 0.5-8WH: Manufactured by Phoenix Contact
• Caulking tool:
CRIMPFOX 6
(or CRIMPFOX 6T-F
Caulking tool
*3
CRIMPFOX 6
(or CRIMPFOX 6T-F
3.2 European Terminal Board
Crimp
terminal
2NC
Termination
*1
: Manufactured by Phoenix Contact
*2
: Manufactured by Phoenix Contact)
• Stranded wire/solid wire
9mm
(0.36")
• Bar terminal with insulating sleeve
Insulating sleeve
Contact portion
(Crimp area)
2.6mm
(0.11")
14mm(0.56")
*4
)
Series input/
8mm
(0.32")