Table of Contents
Advertisement
Program example
• The following program turns Y10 and Y14 ON 10 seconds after X0 has gone ON.
[Ladder Mode]
(1) The setting value of the low-speed timer indicates its default time limit (100ms).
• The following program uses the BCD data at X10 to X1F as the timer's set value.
[Ladder Mode]
[List Mode]
Instruction
Step
• The following program turns Y10 ON 250ms after X0 goes ON.
[Ladder Mode]
(1) The setting value of the high-speed timer indicates its default time limit (10ms).
(1)
Converts the BCD data at X10 to X1F to BIN
and stores the converted value at D10.
When X2 is turned ON, T2 starts measurement
using the data stored in D10 as the set value.
Y15 goes ON at the count-up of T2.
Device
(1)
[List Mode]
Instruction
Step
[List Mode]
Instruction
Step
5 SEQUENCE INSTRUCTIONS
Device
Device
5.3 Output Instructions
5
153
Advertisement
Table of Contents
