Speed Dialing (Specifying A Destination Using An Address Number); Specifying A Destination Using A One-Touch Button - Fuji Xerox ApeosPort-VI C7771 User Manualline

Fax
1
Enter a fax number using the numeric keypad.
Note
2
Press the <Start> button.

Speed Dialing (Specifying a Destination Using an Address Number)

You can use address numbers to specify recipients. Register the address numbers for speed
dialing in advance.
Reference
4
Note
1
Press the <Speed Dial> button, and enter a 4-digit address number.
Note
2
Press the <Start> button.
3
Confirm the destination displayed on the touch screen, and then select [Yes].

Specifying a Destination Using a One-Touch Button

You can use the one-touch buttons to specify recipients. One-touch buttons correspond to
the address numbers from 0001 to 0070, or 0001 to 0060. For example, when the number
you want to dial is registered to the address number 0001, press one-touch button <1>.
Reference
Note
220
If you have entered an incorrect value, press the <C (Clear)> button and enter the correct value.
When you specify address numbers, confirm that the corresponding fax numbers are correctly registered on the machine. For
information on how to register address numbers, refer to "Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
If you have entered an incorrect value, press the <C (Clear)> button and enter the correct value.
You can specify only fax recipients using address numbers for the Simple Fax service. The numbers registered
for the Internet Fax service IP Fax (SIP) cannot be specified.
If you have entered an incorrect value, press the <C (Clear)> button and enter the correct value.
For information on how to register address numbers, refer to "Tools" > "Setup" > "Add Address Book Entry" in the Administrator
Guide.
There are two ways in which address numbers and stored programs are assigned to the one-touch buttons.
Select either of the following. By default, [Type 1] is selected.
[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered address numbers
0001 to 0070, while the buttons M01 and M02 are used for stored programs and they correspond to the
registered stored programs 1 and 2.
[Type 2]