Fuji Xerox ApeosPort-VI C7771 User Manualline page 29

5. Press the <RESET> button to the reset position. The button will be
depressed even after the pushing force is released.
<RESET> button
6. Press the <TEST> button lightly with a sharp edge such as a pen tip. The
depressed <RESET> button will stick out again. This is the end of the check
procedure.
<TEST> button
7. Press the <RESET> button back to the depressed position. If the circuit does
not work properly, contact your local Fuji Xerox representative.
Do not attempt to remove a paper deeply jammed inside the product,
particularly a paper wrapped around the fusing unit or the heat roller.
Otherwise, it may cause injuries or burns. Switch off the product immediately
and contact your local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Waste staples may come out with output paper. Be careful not to get injured
by the staples.
Never touch safety interlocks. When a front cover is open, safety
interlocks become activated to stop the machinery. Do not apply pressure on
safety interlocks with a coin or screwdriver. Otherwise, the machinery
may become activated and cause injuries.
Safety Notes
1
29