Configuring The Ident Profile (Rfid Standard Profile) - Siemens SIMATIC MV440 Operating Instructions Manual

10.3.2

Configuring the Ident profile (RFID standard profile)

For a detailed description of the parameter assignment and commissioning of the RFID
standard profile FB, refer to the relevant RFID function manual (J31069-D0179-U001-A1-
0018).
The following blocks are required in the S7 project:
● "RFID standard profile FB"
(FB101, FB116 or FB132 depending on the length of the data to be processed)
● "Instance DB RFID standard profile", field that can hold 10 commands.
A command is a complex variable of the type "PIB_COMMAND"
RXBUF and TXBUF for result or job data (command data area).
Input parameters
The following input parameters have a different meaning from the description in the function
manual of the RFID standard profile:
Variable
INIT
Output parameters
The following output parameters have a different meaning from the description in the
function manual of the RFID standard profile:
Variable
RPTACT
TPC
TP
UIN0-1
Initialization
During initialization (INIT), the Ident profile automatically executes the "WRITE-CONFIG"
command (see function manual for RFID Standard Profile, RFID Systems J31069-D0179-
U001-A2-0018).
The parameter values of the "WRITE-CONFIG" command depend on whether the Ident
profile is used with or without a communication module.
SIMATIC MV420 / SIMATIC MV440
Operating Instructions, 04/2013, A5E02371045-06
Value/description
For information on initializing the ASM or on acknowledging a group error of the reader,
refer to chapter Group errors (Page 267).
Value/description
Not supported
No significance
No significance
See description Status displays of the MV reader (Page 245)
Process interfacing via an automation system (PLC, PC)
10.3 Control with FB 45 and Ident profile
243