Siemens SIMATIC MV440 Operating Instructions Manual page 345

Error code Message (%s)
(%c)
0014 Only m of the expected number of 1D/2D codes
found in step n
0015 Maximum number of codes per image (m)
exceeded in step n
0016 Exceeded maximum decodable data length in
code m of step n
1006 No Text found in step n
1007 Text too short in step n
1008 Text too long in step n
1009 Quality too low in step n
1010 Match failure in step n
1011 Missing preknowledge for step n
4700 Verification Process Error in step n
4701 Verification Unsupported in step n
4709 Mean light out of range in step n
4710 ISO Verification ECC200 required in step n
4711 ISO Verification aperture too small in step n
4712 ISO Verification aperture too large in step n
4713 ISO Verification insufficient space in step n
4714 ISO Verification failed RDA STEP F1 in step n
4715 ISO Verification failed RDA STEP F2 in step n
4716 ISO Verification failed RDA STEP F3 in step n
SIMATIC MV420 / SIMATIC MV440
Operating Instructions, 04/2013, A5E02371045-06
Alarm, fault and system messages
11.2 Reporting diagnostics information
Description
Only m instead of the expected number of codes was
found in step # n with multicode decoding.
More than the maximum number of codes were found
with multicode decoding (per image: 50 (MV440 UR:
150)).
A maximum of 3001 bytes can be decoded per step.
This amount was exceeded for code #m in step #n.
OCR: No text found in step #n.
OCR: The text found in step #n is shorter than the
configured minimum.
OCR: The text found in step #n is longer than the
configured maximum.
OCR: The text found in step #n is below the
configured quality threshold.
OCR: The match performed in step #n was not
successful.
OCR: There is no string specification available for
step #n.
"Siemens DPM" verification reports: Not enough
space around the data matrix code in step #n.
The selected verification method is not supported for
the code type found in step #n.
"AIM DPM" verification reports: Average brightness
value is out of range (70% ... 86%) in step #n.
Verification according to "ISO15415" and "AIM DPM"
does not support data matrix codes that are not
ECC200. The error occurred in step #n.
The cell size of a data matrix code in step #n is too
large for the set aperture.
The cell size of a data matrix code in step #n is too
small for the set aperture.
"ISO15415" or "AIM DPM" verification reports: Not
enough space around the data matrix code in step #n
"ISO 15415" or "AIM DPM" verification reports an
error during the reference decoding according to
ISO/IEC 16022:2006 in step f), 1 to 6 for page 1. The
error occurred in step #n.
"ISO 15415" or "AIM DPM" verification reports an
error during the reference decoding according to
ISO/IEC 16022:2006 in step f), 1 to 6 for page 2. The
error occurred in step #n.
"ISO 15415" or "AIM DPM" verification reports an
error during the reference decoding according to
ISO/IEC 16022:2006 in step f) 7. The error occurred in
step #n.
343