Panasonic DBS 40 Operating Manual page 58

Section 700 - Operation
Technical Manuals Online! - http://www.tech-man.com
4. From your terminal communications program, type the following
command:
5. After the DBS responds, type P and then press Enter.
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
Terminal Programming Through BISA
Note: The DBS must be equipped with an MFR card and a RAI card to a!low
terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
2. Once you are connected, type #69999 from your terminal communications
program.
3. After the DBS responds with REMT>, type P
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and a RAI card to allow
terminal programming using this method.
When programming through a normal trunk, perform the folloiving steps:
I. Dial into the DB S through a normal trunk.
2. Ask the operator to place you on hold and dial #69999 to transfer you into
remote programming.
3. After the DBS responds with REMT>, type P and then press Enter.
Follow the directions on the screen to access the desired program. (See
"Terminal Programming Commands.")
DBS ManuaT-ksued 8/l I95
Chapter 2. System Features
then press Enter.
and
Page 2-43