Register Customer; Register Installer; Phone Number Programming; Number Prefix - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

Comms > Commands >

Register Customer

Reserved
Comms > Commands >

Register Installer

Reserved
P H O N E N U M B E R P R O G R A M M I N G
Comms > Telephone Numbers >

Number Prefix

1
The number prefix allows you to program the customer
account number and pass code (PIN) to access the
telephone line exchange when using a pre-paid telephone
account (e.g. Telstra Communic8 Pre-Paid Home account),
or when a number followed by a pause is required to get
an outside line on a PABX system.
The number prefix is global for all telephone numbers
programmed in both Destination 1 and Destination 2
(including the domestic telephone numbers and call
forward sequences). the prefix will be dialled immediately
before the number.
1) Enter [MENU] + [5] + [1] + [0]. The keypad will
display the current Telco Number Prefix.
Number Prefix
Press  OK to SAVE
2) Using the numeric keys, enter all the digits of the
telephone number prefix. You can change a single
digit by scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
9-4
Comms Programming

-
MENU 5-0-8
 
MENU 5-0-9

MENU 5-1-0

Digits
Comms > Telephone Numbers >

Destination 1

1
Phone 1
1
Phone 2
1
Phone 3
1
Phone 4
1
Phone 5
This menu sets the primary telephone number for Report
32
Destination 1. This will typically be the primary base
station receiver number. The master code user can only
change telephone numbers when the destination is set to
report in domestic format, voice format or SMS format.
1) Enter [MENU] + [5] + [1] + [1].
If the control panel is not programmed to report using
one of the self monitoring formats, the keypad will
display the following:
Reporting format does
not allow user changes.
Contact installer for
further information
2) If the control panel has been configured to report
via a self monitoring format, the keypad will
display information for telephone number 1.
Phone 1= 0453287306
Phone 2=
Phone 3=
Press
3) Use the [] and [] keys to select the phone number
to add or change, then press [OK] to select.
The keypad will display the following:
Destination 1 Phone 1
0453287306_
Press
4) Use the [] and [] keys to scroll the cursor left
and right across the phone number. Use the []
and [] keys to change the individual digit in the
number or press the [OFF] key to clear the whole
number and then enter the new number using the
[0]-[9] keys.
-
 
Digits
Digits
Digits
Digits
Digits

OK or MENU

0-9 OK to SAVE
Bosch Security Systems 07/14 BLCC610I
MENU 5-1-1
32
32
32
32
32