Call Forward On Number; Call Forward Off Number; Customer; Send Test Report - Bosch Solution 64 User Manual

6. Using the numeric keys, enter all the digits of the third
telephone number (if required).
You can change a single digit by scrolling the cursor left [ ]
and right [ ]. For special characters (eg. , = pause * or
# etc), use the [ ] and [ ] keys. To clear all text from the
cursor position to the right, press the [OFF] key.
7. Press [OK] to save and exit, or press [MENU] to cancel.
Comms > Commands >

Call Forward On Number

When you leave your premises, you no longer need to
remember to manually activate the Call Forward On feature
via the telephone. These addresses allow you to program the
Call Forward On sequence that the Solution control panel will
automatically use when you turn Area 1 'On'.
In Australia, a typical sequence of activating the Call-Forward On
– After Time (All Calls) is described below:
For other countries please substitute the appropriate
commands after consultaion with your telephone company.
1. *61 (To turn Call Forward On – After Time).
2. Telephone number that you want calls to go to (e.g.
0416123456).
3. *5# (End of Call Forward sequence after 5 seconds).
Therefore, you would program the above steps as follows:
*610416123456*5#.
1. Enter [MENU] + [5] + [1] + [6].
The keypad will display information for telephone number 1.
Call Forward On N001
Press
2. Using the numeric keys, enter all the digits of the call
forward on sequence.
You can change a single digit by scrolling the cursor left [ ]
and right [ ]. For special characters (eg. , = pause * or #
etc), use the [ ] and [ ] keys.
3. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Bosch Security Systems | 12/05 | BLCC110U
MENU 5-1-6
0-9 OK to SAVE
Comms > Commands >

Call Forward Off Number

When you enter your premises, you no longer need to remember
to manually disable the Call Forward feature via the telephone.
These addresses allow you to program the Call Forward Off
sequence that the Solution control panel will automatically use
when you turn Area 1 'Off'.
In Australia, a typical sequence of activating the Call Forward Off
feature is described below:
For other countries please substitute the appropriate
commands after consultaion with your telephone company.
1. #61 (To turn Auto-Forward After Time - Off).
2. # (End of Call-Forward sequence).
Therefore, you would program the above steps as follows:
#61#
1. Enter [MENU] + [5] + [1] + [7].
The keypad will display the current call-forward off sequence.
Call Forward Off N001
_
Press
2. Using the numeric keys, enter all the digits of the call
forward off sequence.
You can change a single digit by scrolling the cursor left [ ]
and right [ ]. For special characters (eg. , = pause, * or #
etc), use the [ ] and [ ] keys.
3. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Comms > Registration >

Customer

Reserved
Comms > Periodic Test >

Send Test Report

This menu allows you to test the reporting functions of the
Solution control panel by manually sending a 'Test' report to the
receiving party (i.e. security company monitoring station, mobile
telephone etc).
1. Enter [MENU] + [5] + [9] + [0].
The keypad will prompt that it is in the process of sending a
test report.
Comms testing in
progress. Please wait..
To Go Back Press OK
Solution 64 | User Guide
MENU 5-1-7
0-9 OK to SAVE
MENU 5-5-0
MENU 5-9-0
21