User Default Table; User Pins; Erase User - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

Example:
Prox reader operating door and arm/disarm Area 1.
1) Assign proximity reader 9 to a door assignment 1 -
16, say 4.
2) Set an output event type = door and index = 4.
3) Assign user to door 4, a user can belong to multiple
doors.
4) Assign reader to area 1, enable arming/disarming
and badging options.
5) Present token to disarm, present token to release
door, present token 3 times to arm Area 1.
U S E R D E FAU LT TA B L E
Parameter
Add PIN
Name
Area Assignment
User Options
Master User
Reserved
Arm Only
Can Bypass
Auto Bypass Allowed
Always Report Op/Cl
Reserved
Log Credential
TimeZone Access
Door Assignment
Table 19: User Default Programming Options
5-2
Access Programming

User 1 User 2 - 255
2580
User 1 User 2 - 255
1 1
Y
Y Y
Y Y
Y Y
U S E R P I N S
At factory default, each PIN is set to 4 digits in length.
The default PIN for User 1 (master user) is 2580. Only the
installer can change the PIN length - see MENU 1-5-0 —
PIN Length.
Access > Commands >

Erase User

This menu allows the installer or master user, to erase
another user. When a user is erased, it will return back to
factory default all information relating to the following:
™ PIN
™ Token ID
™ RF Keyfob ID
™ Fingerprint ID
™ Name
™ TimeZone Access
™ Door Assignment
™ Area Assignment
1) Enter [MENU] + [1] + [0] + [0].
2) Use the arrow keys to highlight the user to be
erased then press [OK].
Ur1 John Smith
Ur2 Debbie Smith
Ur3 User 3 Name

Press OK or MENU
3) Verify the user name to be erased and press [OK].
To abort press [MENU].
To erase Ur1
John Smith
press OK.
Press OK or MENU
-
  MENU 1-0-0
Bosch Security Systems 07/14 BLCC610I