Call Forward Off; Comms Properties; Call Attempt Count - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

Comms > Telephone Numbers >

Call Forward Off

1
# 6 1 #
The panel is also able to deactivate certain Telco services
such as Call Forwarding when the system is disarmed.
This means that your customer will no longer need to
remember to manually deactivate Call Forwarding when
they disarm the system.
MENU 5-1-7 allows you to program the Call Forward
Off number sequence. When disarmed the panel will
automatically seize the phone line and dial the number
sequence and then hang up.
In Australia, a typical sequence for deactivating the Call-
Forward On feature (All Calls) might be:
#61 = diversion type - Call Forward On -
Immediate - Disable.
# = end of sequence
1) Enter [MENU] + [5] + [1] + [7]. The keypad will
display any current Call Forward Off sequences.
Call Forward Off
#61#
Press  OK to SAVE
2) Using the numeric keys, enter all digits for the
sequence. You can change a single digit by scrolling
the cursor left or right. For special characters
including, pause, * or #, use the up and down
arrow keys.
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
9-6
Comms Programming

-
  MENU 5-1-7
Digits
#61 #
CO M M S P R O P E R T I E S
Comms > Properties >

Call Attempt Count

32
This menu programs the maximum number of call
attempts the panel will make per destination in order to
deliver the report signal.
At factory default, the maximum number of call attempts
per event is 6 when reporting to a single destination and
12 attempts when reporting to 2 destinations. (6 attempts
per destination)
1) Press [MENU] + [5] + [2] + [0]. The keypad will
display the current number of call attempts per
destination. (Default = 6).
Call Attempt Count
6
Press 0-9 OK to SAVE
2) Using the numeric keys, enter the required number
of call attempts per destination.Valid entries are 1
to 10. 0 = reporting disabled
3) Press [OK] to save and exit or press [MENU] to exit
without saving.
Setting the Call Attempt count to zero will disable all
i
reporting for Destination 1 and Destination 2
Note
 MENU 5-2-0
Bosch Security Systems 07/14 BLCC610I
0 6