User Ras Pin; Customer Registration; Send Test Report; Devices And Optional Modules - Bosch Solution 16i User Manual

Solution16 User Guide
i
4. Using the numeric keys, enter all the digits of the
call forward off sequence.
You can change a single digit by scrolling the cursor
left [←] and right [→]. For special characters (eg. , =
pause * or # etc), use the [↑] and [↓] keys.
5. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Comms > Commands >

User RAS PIN

Reserved for future use
Comms > Registration >

Customer Registration

Reserved for future use
Comms > Periodic Test >

Send Test Report

This menu allows you to test the reporting functions of the
control panel by manually sending a 'Test' report to the
receiving party (i.e. security company monitoring station,
mobile telephone etc).
1. Enter [Master PIN] + [MENU]
2. Enter [5] + [9] + [0] + [OK]. The test will begin
and the keypad will display that testing is in the
progress. The test can take up to 1 minute to
complete.
If the test is successful, the keypad will prompt:
If the test is NOT successful, the keypad will prompt:
3. Press [OK] or [MENU] to exit.
24
Ur ras
MENU 5-3-8
Cusreg
MENU 5-5-0
tst-dl
MENU 5-9-0
ph tst
pAss
fAil

Devices and Optional Modules

Programming options in this section relate to the keypads
and other devices which may be connected to your
alarm system. Your installer will advise you on the exact
configuration of your system.
Devices > Commands >

LAN Status

This menu provides a listing of all of the devices and
modules connected to your system. Using this option
it is possible to view the voltage, temperature and other
information about each of the modules.
1. Enter [Master PIN] + [MENU]
2. Enter [MENU] + [6] + [0] + [0] +[OK]. The keypad will
display the first device fitted to the system.
3. Use the [↑] and [↓] keys to select the device that you
want to view, then press [OK] to select.
4. The system will now step through each parameter
for the selected device. See the examples below for
a connected keypad.
5. The system display CP001 which represents Keypad
number 1 on the system. Press [OK[ to view.
6. The display will show each parameter for the device
one at a time.
Display shows the
current keypad
temperature.
Displays the current
voltage being
measured at the
keypad.
Displays the firmware
version of the keypad.
Displays the keypad
size. 8 Zone or
16 Zone
Displays if the
keypad has an inbuilt
proximity reader.
4. Press [OK] or [MENU] to exit.
LAN-St
MENU 6-0-0
CP001
t=22c
U=13-8
U=1-00
16 Zn
pro
Bosch Security Systems 10/07 BLCC500U FTR1.01