Call/Answer Ras; Call Forward On/Off; Check Web Email; Email System Log - Bosch Solution 144 User Manual

Solution 144 User Guide
Comms > Commands >

Call/Answer RAS

This menu allows you to initiate a modem call to the
installer's off-site computer for programming changes or
updates. Your installer may request that you enter this
command so that they can remotely service and configure
your system. You should not enter this command unless
requested to do so.
Comms > Commands >

Call Forward On/Off

This menu allows you to turn on and off the call forward
feature. When you turn on call forwarding, the control
panel will automatically activate and de-activate the call
forward on and call forward off sequence accordingly
when you turn Area 1 All On and off (arm and disarm).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [2].
If the call forward status is off, the keypad will
display:
Call Forward On/Off
Call Forward is OFF.
To turn ON, Press ON.
To Go Back Press OK
If the call forward status is on, the keypad will
display:
Call Forward On/Off
Call Forward is ON.
To turn OFF, Press OFF.
To Go Back Press OK
2. To toggle call forward on, press the [ON] key or press
the [OFF] key to turn call forward off.
3. Press [OK] to save and exit, or press [MENU] to
cancel.
The call forward on/off can be used to automatically
i
divert your home phone to you mobile phone when
Note
the system is armed and automatically cancel the
diversion when the system is turned off. See MENU
5-1-6 for more details.
Comms > Commands >

Check Web Email

Reserved for future use
Comms > Commands >

Email System Log

Reserved for future use
28
Comms > Commands >

Start Direct Connect

MENU 5-0-1
This menu allows the master user to start a direct link
session. You should discuss this option with your installer.
Comms > Commands >

Voice Setup

This menu allows the master user to record their own
customised greeting and zone description messages
that will be played back to users that are programmed to
receive voice reports from the alarm system.
MENU 5-0-2
Messages should clearly describe the premises and zones
so that the user receiving the telephone call from the
control panel can then take the appropriate action.
This feature requires an optional voice module to be fitted
to the system by your installer. Additional programming
information is included with the voice module.
Comms > Commands >

Register Customer

Reserved for future use
Comms > Telephone Numbers >

Destination 1

The installer may have configured your system to report
alarm messages using one of the self monitoring formats
such as SMS, Domestic or Voice reporting. When one of
these formats has been configured the system will send
alarm reports to a phone number or numbers belonging to
you and or other family members.
Depending on the selected format the system is capable
of reporting alarm messages to 5 different numbers on
destination 1 and an additional 5 numbers on destination
2 if required. Each number can be up to 32 digit long.
When SMS format is selected the system will send alarm
reports to all numbers programmed in the destination.
When voice reporting is selected the user who answers the
call can choose whether the message is also sent to other
numbers in the destination 1 list or not.
When reporting in domestic format, the call must be
acknowledged by the user who answers the incoming call.
If the user fails to acknowledge the call, the system will call
MENU 5-0-3
the next number in the list until the maximum number of
call attempts are reached.
To acknowledge the call, the user needs to press the [#] key
MENU 5-0-4
on their telephone.
MENU 5-0-5
MENU 5-0-6
MENU 5-0-8
MENU 5-1-1
Bosch Security Systems 04/12 BLCC600U