Playing Back A Message; Recording New Messages - Bosch solution 6000 Installation Manual

Playing Back A Message

4) The system will then prompt you to Enter the
message number followed by the [OK] key. Enter
the message number on the alarm keypad and
press the [OK] key.
Zone 1 Message
Zone 2 Message
Zone 3 Message

Press OK or MENU
Alternatively, you can use the [UP] and [DOWN] keys
to scroll to the message required, then press [OK] to
select.
Refer to the voice module instruction sheet
for a complete list of the message numbers.
The keypad will display the following below whilst
playing the current recorded message via the
telephone.
Playing
Zone 1 Message
Press OK or MENU
5) After the message has been played, the system will
automatically return to the main menu as shown in
step 5 above.
Bosch Security Systems 07/14 BLCC610I
Solution 6000
Installation Manual


Recording New Messages

To record a new message, follow the instructions in steps
1 to 3 above and then,
i For the best
messages speak
Note
the mobile
much background
We do not recommend recording using hands free
operation.
4) The system will then prompt you to Enter the
message number followed by the [OK] key. Enter the
message number on the alarm keypad and press
the [OK] key.
Zone 1 Message
Zone 2 Message
Zone 3 Message

Press OK or MENU
Alternatively, you can use the [UP] and [DOWN] keys
to scroll to the message required, then press [OK] to
select.
Refer to the voice module instruction sheet
for a complete list of the message numbers.
5) On the mobile phone you will hear a short beep
indicating that recording has begun. You should
now speak clearly into the mobile phone to record
the new message as required and press [OK] when
finished.
Recording
Zone 1 Message
Press OK or MENU
If the message duration expires before you finish
recording you will hear a long beep indicating that
recording has finished. If this happens you may need
to speak a little faster when recording or shorten the
actual message to fit in the available message space.
6) You should now follow the instructions to playback
the message. When you are happy with the newly
recorded message repeat the steps to customise
the remaining messages. If you would like to
overwrite or re-record the same message again
simply repeat the appropriate steps until you are
satisfied.
Currently it is not possible to reset the
i
programmable
Note
factory default settings.
Comms Programming

results when recording
loudly and clearly
phone and reduce
noise as possible.
messages back to
into
as
the
9-3