Lan Scan; Lan Watch; Keypad Volume; Keypad Contrast - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

Devices > Commands >

LAN Scan

This menu allows the installer to rescan a non-secured
LAN network when adding or removing LAN expansion
devices (eg. keypads, input modules, output modules
etc), without the need to power down the control panel.
1) Press [MENU] + [6] + [0] + [2]. If the system LAN is
not secured, the keypad will display the following.
LAN scan has been
requested. This will end
your login session
....Please Wait
Scanning LAN for Devices
Please Wait ... /
Found Output Exp 2
Devices > Commands >

LAN Watch

This menu allows the installer to view the number of
retry packets that are being sent out on the bus on a per
module basis.
The menu list is structured with the Packet Retry Count
followed by Device ID then the Device Name. Simply
scroll through the list with the arrow keys to view the
devices.
Move the cursor to the device of interest and press the
OFF key to reset the Packet Retry Count or press and hold
down the OFF key to reset the Packet Retry Count for all
devices.
The packet retry count is also reset on power up and
continues to count upwards on an ongoing basis
and once reaches the maximum of 255 will stop until
manually reset.
Under normal circumstances a device should not have a
large retry count but over time this is possible.
1) Press [MENU] + [6] + [0] + [3] and use the up and
down arrows to highlight the device in the list.
001 Fp2 Keypad 1 Name
017 Kp1 Keypad 3 Name
010 Kp1 Keypad 5 Name
Press  OK or MENU
2) Press [OK] or [MENU] to exit.
10-2
Device Programming

MENU 6-0-2

MENU 6-0-3

Devices > Commands >

Keypad Volume

This menu allows you to adjust the volume of the keypad's
speaker to suit the application or customer preference.
Each keypad on the system can be adjusted separately.
1) Press [MENU] + [6] + [0] + [7] and use the up and
down arrows to highlight the keypad in the list
then press [OK].
Keypad 001 Volume
L
Press
2) Use the arrow keys to set the required volume level.
Each time a key is pressed, you will hear a beep
indicating the new volume level. When finished
press [OK].
To completely silence the keypad speaker, simply
i
move the slider all the way to the left. This will disable
Note
the keypad speaker for all functions including key
press beeps.
Devices > Commands >

Keypad Contrast

This menu allows you to adjust the contrast of the keypad's
LCD display to suit the application or customer preference.
Each keypad on the system can be adjusted separately.
1) Press [MENU] + [6] + [0] + [8] and use the up and
down arrows to highlight the keypad in the list
then press [OK].
Keypad 001 Contrast
L
Press
2) Use the arrow keys to set the required contrast
level. Each time a key is pressed the contrast will
adjust to the new level. When finished press [OK].
Devices > Commands >

Keypad Backlight

This menu allows you to adjust the brightness of the
backlight on the keypad's LCD display. Each keypad can
be adjusted separately to suit the customers needs.
-
  MENU 6-0-7
H
OK to SAVE
-
  MENU 6-0-8
H
OK to SAVE
-
  MENU 6-0-9
Bosch Security Systems 07/14 BLCC610I