Solution 6000
Installation Manual
Areas > Area Testing >
Test Options
1
User Test Required
2
Reserved
3
Reserved
4
Reserved
5
Reserved
6
Walk Test Report
7
Walk Test 24Hr
8
Walk Test Fire
The above options are programmable per area.
1) Enter [MENU] + [2] + [9] + [3] and select the area
from the list then press [OK].
2) Use the up and down arrow keys to highlight the
option then press the [ON] key to enable or the
[OFF] key to disable.
User Test Required
Reserved
Reserved
Press
OK ON OFF MENU
3) Repeat Step 2 until all options are programmed as
required, then press [OK] to save and exit or press
[MENU] to exit without saving.
User Test Required
This option allows the keypad assigned to the
corresponding area to display a trouble condition when a
user test is due. The trouble condition can be cleared by
performing a walk test.
Walk Test Report
This option allows the corresponding area to send 'Walk
Test' reports when a user enters/exits walk test mode and
test zones.
Walk Test 24Hr
This option allows any 24-hour (non-fire) zone assigned
to the corresponding area to be tested during walk test.
Walk Test Fire
This option allows 24-hour fire zone assigned to the
corresponding area to be tested during walk test.
» » E N D
6-12
Area Programming
MENU 2-9-3
S E C T I O N « «
O F
Y
N
N
N
N
Y
N
N
Bosch Security Systems 07/14 BLCC610I