Install Oil Pan - Toyota 7M-GE Repair Manual

bf3lCA~l0N
SYSTEM
- Oil Pump
2. INSTALL OIL PAN
(a) Remove any old packing (FIPG) material and be care-
ful not to drop any oil on the contact surfaces of the
oil pan and cylinder block.
l
Using a razor blade and gasket scraper, remove all
the packing (FIPG) material from the gasket sur-
faces.
0 Thoroughly clean all components to remove all the
loose material.
l
Clean both sealing surfaces with a non-residue
solvent.
CAUTION:
Do not use a solvent which will affect the
painted surfaces.
ib) Apply seal packing to the oil pan as shown in the
figure.
Seal packing:
Part No. 08826-00080 or equivalent
0 Install a nozzle that has been cut to
a 5 mm (0.20
in.) opening.
(c) Install the oil pan with the bolts and nuts.
Torque :
130 kg-cm (9 ft-lb, 'I3 N-m)
3. FILL WITH ENGINE OIL (See step 3 on page LU-7)
4. START ENGINE AND.CHECK FOR LEAKS
'.
5.
RECHECK OIL LEVEL (See step 2 on page LU-5)