Installation Of Cylinder Head; Install Cylinder Head Covers - Toyota 7M-GE Repair Manual

ENGINE MECHANICAL - CylinderHead
EM&Q
C Front
EX
:
CYLINDER
(See pages EM-37, 38)
1. INSTALL CYLINDER HEAD
(a) Apply seal packing to the two i
Seal packing: Part No. 08826-00080 or equiyafent
(b) Place a new cylinder head gasket on the cylinder
block.
CAUTION: Be careful of direction.
!
(c) Place the cylinder head on the cylinder head gasket,
and connect the No.5 water by-pass hose to the
union.
Id) Apply a light coat of the.,engine oil on the threads and
under the cylinder head 'bolts.
(e) Using SST, install and uniformity tighten the fourteen
cylinder head bolts. in several passes and in the
sequence shown.
SST 09043-38 100
Torque: >800 kg-cm (E8 ft-lb, 78 N=m)
2.
3.
4.
INSTALL CAMSHAFT TIMING PULLEYS AND TIMING
BELT
(See steps 8 to 12 and 14 on pages EM-34 to 36)
INSTALL SPARK PLUGS
(See page 16-71 ~
INSTALL CYLINDER HEAD COVERS
(a) Using SST, install the No.3 cylinder head cover and
heater hose clamp.
SST 09923-00010
in.
Torque:
180 kg-cm (13 ft-lb, 18 N.m)