Installation Of Cylinder Head - Toyota 3F-E Repair Manual Supplement

EM-28
ENGINE MECHANICAL — Cylinder Head

INSTALLATION OF CYLINDER HEAD

(See page EM-17)
1. INSTALL CYLINDER HEAD
(a)
Place a new cylinder head gasket on the cylinder
block.
NOTICE: Be careful of the installation direction.
(b) Place the cylinder head on the cylinder head gasket.
(c) Apply a light coat of engine oil on the threads and
under the cylinder head bolts.
(d)
Install and uniformly tighten the ten cylinder head
bolts with the plate washers in several passes, in the
sequence shown.
Torque: 1,250 kg-cm (90 ft-lb, 123 N•m)
2. INSTALL PUSH RODS
Install the twelve push rods.
3. INSTALL VALVE ROCKER SHAFT ASSEMBLY
(a) Place the rocker shaft assembly on the cylinder
head.
(b) Align the rocker arm adjusting screws with the
heads of the push rods.
(c) Install and uniformly tighten the eight bolts and four
nuts in several passes, in the sequence shown.
Torque:
12 mm bolt head
240 kg-cm (17 ft-lb, 24 N•m)
14 mm bolt head and nut
340 kg-cm (25 ft-lb, 33 N•m)